Eicon Networks C20 Manuel d'instructions Page 334

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 410
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 333
INTUITY Messaging Solutions Release 4
MAP/5P Maintenance
585-310-186
Issue 3
October 1997
System Configuration
Page A-6Component Assignments
A
Fixed Assignments
The following bay assignments are fixed in the MAP/5P:
Bay 1 Cartridge Tape drive
Bay 2 — Empty
Bay 3 — Empty
Bay 4 — Diskette drive
Bay 5 — Hard Disk Drive 1 (if provided)
Bay 6 — Hard Disk Drive 0
Bay 7 — Empty
The following slot assignment is fixed in the MAP/5P:
PCI Slot 1 SCSI controller circuit card
ISA Slot 2 — remote maintenance circuit card
Variable Assignments
The Tip/Ring, ACCX, LAN, Multi-port, and switch interface circuit cards all have
variable assignments in the MAP/5P. These assignments depend on how many
cards have been installed. The following rules apply to the placement of optional
cards in the MAP/5P. These rules presume that the required circuit cards are
placed in the MAP/5P as specified in “Fixed Assignments” above.
A maximum of three Tip/Ring circuit cards is supported.
All other circuit cards are supported as one per system.
Tip/Ring circuit cards are assigned slots sequentially, starting, at the
bottom, with slot 6.
The ACCX circuit card is assigned in the lowest numbered available slot
after all Tip/Ring circuit cards have been installed. For example, if
Tip/Ring circuit cards are installed in ISA Slot 5 and ISA Slot 6, place the
ACCX circuit card in ISA Slot 4.
The LAN circuit card, if provided, goes in the lowest numbered available
ISA slot.
The switch interface circuit card, if provided, goes in the lowest numbered
available ISA slot after the LAN circuit card, if provided, has been
installed.
The multi-port serial circuit card, if provided, goes in the lowest numbered
ISA slot after both the LAN and switch interface circuit cards, if provided,
have been installed.
Vue de la page 333
1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 409 410

Commentaires sur ces manuels

Pas de commentaire