Eicon Networks C20 Manuel d'instructions télécharger pdf (Page 236)

100

101

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing Other Components

Page 7-6CMOS Battery Replacement

protrude from the chassis too far or be recessed into the chassis too

far.

4. Secure the drive in the peripheral bay using the four screws removed in

Step 4

of the procedure, ‘‘Extracting the Cartridge Tape Drive’’, above.

5. Attach the power cable to the cartridge tape drive.

6. Attach the SCSI cable to the cartridge tape drive.

NOTE:

Make sure the SCSI cable pin adapter is attached to the SCSI cable.

Re-assembling the MAP/5P

To re-assemble the MAP/5P, replace the dress cover. See “Replacing the Dress

Cover” in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.

Restoring the Lucent INTUITY System

To restore the Lucent INTUITY system, do the following:

1. Restore power to the MAP/5P. See “Restoring Power to the MAP/5P

” in

Chapter 4, ‘‘Getting Inside the Computer’’

, for the procedure.

2. Verify the Lucent I

NTUITY system operation by placing a call to a user.

CMOS Battery Replacement

CAUTION:

Observe proper electrostatic discharge precautions when you handle

computer components. Wear an antistatic wrist strap that touches your bare

skin and connect the strap cable to an earth ground. See “Protecting

against Damage from Electrostatic Discharge” in Chapter 4, ‘‘Getting Inside

the Computer’’.

The CMOS battery is located on the motherboard (Figure 7-4).

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 409 410

Commentaires sur ces manuels

Pas de commentaire

Eicon Networks C20 Manuel d'instructions Page 236

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Eicon Networks C20