Eicon Networks C20 Manuel d'instructions télécharger pdf (Page 203)

100

101

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing the Hard Disk Drive

Page 6-5Identifying a Failed Hard Disk Drive

Figure 6-3. Maintenance Log Window

5. Verify that there is an entry for a hard disk drive failure.

The hard disk drive will be identified by the name and jumper id.

The disk name is shown in the message text after the word

name

. The

jumper id is embedded in the string of numbers and letters that follow the

word

. The jumper id is the single digit number that follows the letter “t”.

For example, if the text reads

c0t1d0s0, the jumper id is 1.

NOTE:

Note that the jumper ID is the same as the SCSI ID.

NOTE:

A hard disk drive failure can also be identified by entering

in the

Application Code

and

DISK

in the

Resource Type

of the alarm log.

However, to identify the failed disk you must access the maintenance log.

See Chapter 1, “Getting Started,” in

Lucent I

NTUITY

Messaging Solutions

Release 4 Alarms and Log Messages

for the procedure to access the alarm

log.

If Hard Disk Drive 0 has failed, see ‘‘Recovering from a Hard Disk Drive 0 Failure

in a Mirrored System’’ below for the replacement procedure.

If Hard Disk Drive 1 has failed, see ‘‘Recovering from a Hard Disk Drive 1 Failure’’

below for the replacement procedure.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 409 410

Commentaires sur ces manuels

Pas de commentaire

Eicon Networks C20 Manuel d'instructions Page 203

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Eicon Networks C20