Eicon Networks 1530 Guide de l'utilisateur télécharger pdf (Page 85)

Web Interface Settings Glossary 85

VHSI Port Menu > Delays Group

DCD (off) -> RTS (on) Delay

Defines the DCD(off) -> RTS(on) delay.

This is the delay before the remote is allowed to send at the end of reception. This parameter is

intended for non-standard physical interfaces, and is for half-duplex lines only.

Range: 0-9999 milliseconds.

Default: 0 (disabled).

RTS (off->on) Maximum Delay

Defines the RTS (on) -> RTS (off) maximum delay.

This is the amount of time the transmitter may be active before turning the line around. This

parameter is for half-duplex lines only.

Range: 0-9999 milliseconds.

Default: 0 (disabled).

DCD (on->off) Maximum Delay

Defines the DCD (on) -> DCD (off) maximum delay.

This is the maximum length of time the remote device is allowed to transmit data. If this limit is

exceeded the line is disconnected. This parameter is only used for half-duplex lines.

Range: 0-9999 milliseconds.

Default: 0 (disabled).

TX Idle Timeout

Defines the Tx Idle Timeout.

When the transmitter finishes sending a frame, it starts the Tx Idle Timer. If this timer expires

before another frame is available for sending, the transmitter is turned off. This parameter is

only used in half-duplex mode.

Range: 0-9999 milliseconds.

Default: 0 (disabled).

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 161 162

Pas de commentaire

Eicon Networks 1530 Guide de l'utilisateur Page 85