Eicon Networks 1530 Guide de l'utilisateur télécharger pdf (Page 143)

Command Line Interface 143

PPP Commands

ENABLE PPP ENCRYPTED

DISABLE PPP ENCRYPTED

Enables/disables encrypted password to be sent for authentication. If enabled, an encrypted

password is used. This can only be used if the remote supports CHAP authentication. If

disabled, unencrypted password is used and the remote can support either PAP or CHAP

authentication.

Default: Disabled.

ENABLE PPP AUTHENT

DISABLE PPP AUTHENT

Enables/disables password authentication. When enabled, the Eicon 1530 WAN Router will

authenticate the remote, using the username and password (encrypted/unencrypted) received

from the remote.

Default: Disabled (Outgoing), Enabled (Incoming).

SET PPP LPASSWORD localPassword

Defines the password used when replying to valid authentication requests.

Range: 0-31 alphanumeric characters (no spaces). Default: eicon.

SET PPP LNAME localName

Defines the name used when replying to valid authentication requests.

Range: 0-31 alphanumeric characters (no spaces). Default: eicon.

SET PPP RNAME remoteName

Defines the name the remote device must supply when authentication is requested by the

Eicon 1530.

Range: 0-31 characters, no spaces. Default: eicon.

SET PPP RPASSWORD remotePassword

Defines the password the remote device must supply when authentication is requested by the

Eicon 1530.

Range: 0-31 characters, no spaces. Default: eicon.

ENABLE PPP COMPRESSION

DISABLE PPP COMPRESSION

Enables/disables PPP compression. When enabled, one of the following standards is

automatically negotiated: Ascend, MPPC, MS-STAC, STAC 1, and STAC 3.

Default: Disabled.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 161 162

Pas de commentaire

Eicon Networks 1530 Guide de l'utilisateur Page 143