Eicon Networks S93 Guide d'installation télécharger pdf (Page 98)

Installation in Unattended Mode 98

QSIGDialect:

Since several switches apply various Q-Sig protocol variants, it is important that your Q-Sig

configuration corresponds exactly to the switch that you are using. Set the ‘QSIGDialect’

that matches your switch and its Q-Sig standard. See the following table for correct values:

QSIGBriChannelId

Basic rate lines only. Set the channel identifier format for your PBX type. Possible settings

are:

• 0 (Standard): The channel ID is given in PRI format (three bytes).

• 1 (Short): The channel ID length is one byte.

Q-Sig PBX type Q-Sig standard Q-Sig dialect

Generic PBX Automatic 0

Generic PBX ISO 3

Generic PBX ECMA 1

Siemens HICOM 300 ECMAV1 1

Siemens HICOM 300 ECMAV2 3

Siemens HICOM 150 Automatic 0

Siemens HICOM 150 ISO 3

Siemens HICOM 150 ECMA 1

Alcatel 4400, 4410, 4200 Automatic 0

Alcatel 4400, 4410, 4200 ISO 9

Alcatel 4400, 4410, 4200 ECMA 8

Ericsson MD110 ISO 7

Ericsson MD110 ECMA 6

Ericsson BP250 Automatic 6

Lucent Definity Automatic 0

Lucent Definity ISO 3

Lucent Definity ECMA 1

matra6500 Automatic 0

matra6500 ISO 3

matra6500 ECMA 1

Nortel Automatic 0

Nortel ISO 3

Nortel ECMA 1

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 129 130

Pas de commentaire

Eicon Networks S93 Guide d'installation Page 98