Eicon Networks DIVA T/A ISDN Modem Guide de l'utilisateur Page 107

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 146
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 106
DIVA T/A ISDN Modem Users Guide
Page 107
Analog Device Support
Call Waiting
Call Waiting alerts you to a second incoming call during an active call. This feature is available
as a service through your ISDN line (referred to as “ISDN Call Waiting”) and also from the
DIVA T/A modem itself (referred to as “DIV AT/A Call Waiting).
The DIVAT/A’s internal Call Waiting uses the second B-channel (if available) to receive a
second incoming call and offer it to you. However, if both B-channels are in use, DIV AT/A Call
Waiting cannot offer you a call, and the second caller will hear a busy signal. ISDN Call
Waiting is handled by your provider and does not need an available B-channel.
Enabling ISDN Call Waiting
ISDN Call Waiting can only be enabled by your ISDN service provider. If you are unsure if your
ISDN line has this feature, check with your provider.
Enabling and Disabling DIVA T/A Call Waiting
To enable DIVA T/A Call Waiting:
1
Lift the receiver, then wait for a dial tone.
2
Press *43#.
3
Three rising tones are played to confirm Call Waiting has been enabled.
To disable DIVA T/A Call Waiting:
1
Lift the receiver, then wait for a dial tone.
2
Press #43#.
3
Three falling tones are played to confirm that Call Waiting has been disabled.
To determine if Call Waiting is enabled
1
Lift the receiver, then wait for a dial tone.
2
Press *#43#.
3
If enabled, you will hear three rising tones; if disabled, you will hear three falling tones.
Using Call Waiting When Alerted to a Second Incoming Call
In order to use the following keypad commands, your ISDN line must also support Call Hold.
These commands apply to both ISDN Call Waiting and the DIVA T/As internal Call Waiting.
To ignore the incoming call:
1
Do nothing.
2
The two beeps will repeat te nseconds later.
To reject the incoming call:
1
Press R and wait for a dial tone.
2
Press 0.
3
The incoming caller will receive a busy signal. Call Waiting will also be disabled for the
duration of the call.
Vue de la page 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 145 146

Commentaires sur ces manuels

Pas de commentaire