Eicon Networks CX1 Manuel d'installation télécharger pdf (Page 51)

G&R

-SX on/OFF

qsim -li dsa -sx on

This selects Scandinavian transliteration tables for conversion between

EBCDIC and ASCII. The -SX parameter transliterates EBCDIC #@$ to ASCII

[\]. It is seldom used, even in Scandinavia.

-S_ on/OFF

Windows

Server

gspool -id gs1 -ps \\SERVER\LEXMARK

-li dsa -da tptst -s_ on

UNIX

Linux

gspool -id gs1 -pc lp -li dsa -da tptst

-s_ on

This enables the session trace in the line handler. It documents session,

transport and internal events along with inbound and outbound data for the

transport interface. If the -PCO parameter is used then an additional trace file

will be written for the printer session. See section entitled Host Links trace.

-TI xxxx

qsim -li dsa -ti T1234

This defines the terminal id, used by the line handler when connecting to the

remote system. It can be used by the remote system to generate a LID. The

default value is T000.

-TM, -MD, -MDMP xxxxxx

pthru -li dsa -tm vip7804

qsim -li dsa -tm hx2033

This selects the terminal mode that will be delivered to the mainframe. It tells

the application which terminal presentation protocol you will use. See section

Parameters for DSA and DIWS handlers for possible values.

If you need to use some other mode, and know its hexadecimal identification

(see the DNS V4 - Terminal Management Manual), then you can configure it

using -TM HXxxxx, where xxxx is 2 bytes in hexadecimal.

Gline Line Handlers and Configuration

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 132 133

Pas de commentaire

Eicon Networks CX1 Manuel d'installation Page 51