Eicon-networks Adapters Manuel d'utilisateur télécharger pdf (Page 16)

16 Installing the Software

ENGLISH

The Eicon Adapter Setup dialog box appears:

11. From “ISDN Protocol (Switch Type)”, select the switch type speciﬁed by

your ISDN service provider.

In general, if you are in Europe, select “Europe and other countries,

Euro-ISDN (E-DSS1)” (commonly referred to as ETSI standard).

12. If the hardware resources ﬁelds are not grayed out: Ensure that the default

hardware resources (“Interrupt Number” and “I/O Port Base Address”) are

not used by other devices in your computer. If necessary, change the default

values.

Note For the DIVA Server BRI-2M, you can use the following interrupts:

3, 4, 5, 7, 9, 10, 11, 12, 14, and 15.

To determine which hardware resources are used by other devices, click

“Launch Windows NT Diagnostics” and select the “Resources” tab:

• To view which interrupts are used by other devices, click “IRQ”.

• To view which I/O port base addresses are used by other devices, click

“I/O Port”.

• To return to the Eicon Adapter Setup dialog box, click “OK”.

13. From “ISDN Interface Type”, select the type of interface to which the

Server adapter is connected.

• “Standard”: The Server adapter is operated on a standard ISDN bus.

This option is available only if you are using a DIVA Server BRI-2M

adapter.

• “Point to Point”: The Server adapter is operated on a point to point (or

direct dialing) NT2 interface.

• “Leased Line”: The Server adapter is operated on a group 2 leased line.

Typically, BRI adapters use the Standard interface, and PRI adapters use the

Point to Point interface.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

Eicon-networks Adapters Manuel d'utilisateur Page 16