www.eicon.comEiconcard C2x Familyfor ISA-Compatible Bus
10 Making an ISDN ConnectionEiconcard C21 S/T-interface:If your Eiconcard C21 has an S/T-interface, you need a separate NT1. Note You can order an NT
Termination 11TerminationThis section applies to S/T interface users in Australia and North America, and provides instructions to help set up terminat
12 TerminationMultiple ISDN DevicesIf the NT1 is connected to more than one ISDN device, follow the procedures below.75 meters or moreIf the connectio
Making a V.24 Connection 13Making a V.24 ConnectionThe Eiconcard C21 can make V.24 connections using standard V.24 cables. Table 1. Standard Interface
14 The V.24 DCE InterfaceThe V.24 DCE InterfaceA pin-out diagram for the V.24 DCE interface is shown in Figure 6. The signal definitions and names are
LED Functionality 15LED FunctionalityNote The Eiconcard C20 only has the V.24 port, the Eiconcard C21 has both the ISDN BRI port and V.24 port..ISDN (
16 Technical SpecificationsTechnical SpecificationsTechnical Data• PCI bus compatible (32-bit slot)Hardware Installation• Automatic configuration of i
International Regulatory Information 17International Regulatory InformationRegulatory Information for the USA:WARNING. Changes or modifications to thi
18 Regulatory Information for the USA:FCC Part 68 NoticeThis unit complies with Part 68 of the FCC rules. On the bottom of this equipment is a label t
Regulatory Information for Canada 19Regulatory Information for CanadaNOTICE: The Industry Canada label identifies certified equipment. This certificat
www.eicon.comFirst Edition (July 2001) 203-225-01Eicon, Eiconcard, and the Eicon logo are either trademarks or registered trademarks of Eicon Networks
20 Regulatory Information for EuropeRegulatory Information for Europe EU Declaration of ConformityEN: Eicon Networks Corporation declares that this eq
Regulatory Information for Europe 21Safety Status: SELVNo voltages within this equipment exceed SELV voltages. All interconnection points and ports ar
22 Regulatory information for AustraliaRegulatory information for Australia• This customer equipment shall only be installed in a PC that requires the
203-225-01
www.eicon.comTable of ContentsIntroduction ... 5About this Manual...
www.eicon.com
Introduction 5IntroductionThe Eiconcard C2x is an ISA Plug-and-Play (PnP) card that offers X.25 connectivity through a V.24 serial port at speeds of u
6 Installing the Eiconcard C2xInstalling the Eiconcard C2xFollow the steps below to install the Eiconcard C2x. If you want the Eiconcard C2x to be ava
Installing the Eiconcard C2x 7Figure 2. Inserting the Eiconcard C2x.e) Fasten the adapter with the screw (to ensure that the adapter is properly secur
8 Making an ISDN ConnectionMaking an ISDN ConnectionNote Only the Eiconcard C21 supports ISDN connections.After you have installed your Eiconcard C21,
Making an ISDN Connection 9Eiconcard C21 U-interface:If your Eiconcard C21 has a U-interface, the NT1 is integrated into the adapter, and you do not n
Commentaires sur ces manuels